Temperature Controller, XH-W1219 [PC-1114]

Features:

• Control Range: -50~110 °C
• Control Precision: 0.1 °C
• Measuring Input: NTC10K waterproof sensor L=0.5m.
• High-Temperature Alarm: -49~110 °C
• Input Voltage: DC 12V
• Output Type: Relay output 10A (max)
• Return Difference Setting: 0.1~30 °C
• Delay Starting: 0-10min
• Temperature Calibration: -10~10 °C

Parameter:

Model: XH-W1219
Control range: -50°C to 110°C
Control accuracy: 0.1°C
Measurement input: NTC10K waterproof sensor L=0.5M
High temperature alarm: -49°C to 110°C
Input voltage: DC 12V
Output type: relay output up to 10A
Return difference setting: 0.1°C to 30°C
Delayed start: 0-10 minutes
Temperature correction: -10°C to +10°C
Size: 60*43*16mm (length*width*height)

How to restore factory settings:

Under normal power, press and hold the + and – key for about three seconds to restore factory settings.
1. PO temperature control mode:
This value must be set when the thermostat is used for the first time. If it's used for heating, it must be set to H. If it's used for cooling, it should be set to C.
2. P1 difference setting:
Press the SET button for a long time to enter the internal settings, select the P1 setting, then press the SET button again to set the hysteresis value. (The hysteresis is that the difference needed when the thermostat reaches the set temperature and stops working again.)
3. P2 temperature calibration:
This function is used for temperature calibration. If there's a deviation between the detected temperature and the actual temperature, this function can be used to correct. The corrected value = measured value + correction value. (If you do not control the compressor or don't need delay function, skip this item directly)
4. P4 high-temperature alarm:
Set the high-temperature alarm value. When the real-time temperature exceeds this value, the screen will flash a warning alarm.

বিঃদ্রঃ XH-W1219 টেম্পারেচার সার্কিটটিতে দুইটি ডিসপ্লে রয়েছে উপরের সেন্সরে কত তাপমাত্রা পেয়েছে সেটা যেমন দেখা যাবে তেমনি নিচের ডিসপ্লেতে আপনি তাপমাত্রা কত সেট করে দিয়েছেন সেটাও দেখা যাবে অর্থাৎ ডাবল ডিসপ্লে রয়েছে